Renkforce 1582598 Bedienungsanleitung Seite 98

Setting output #1, #2 or #3 to toggle mode with a shorter code (3 digits):
In this mode, you can enter the first three digits of the user code to enable toggle mode. The full
user code must be entered to disable toggle mode. This can be used to allow office staff to turn
on the alarm system using a shorter code whilst ensuring that the alarm can only be turned off
by security personnel.
Follow the steps below:
• The code lock must be in programming mode (see section 12. a) for details).
• Enter the programming code for corresponding output:
Set output #1 to toggle mode with a shorter code
Set output #2 to toggle mode with a shorter code
Set output #3 to toggle mode with a shorter code
• Press the button to confirm your entry. The code lock will beep twice and the "MAINS"
LED will flash two times to indicate that the setting has been saved.
Example: Set output #1 to toggle mode with a shorter code (3 digits):
(a) (b)
(a) Set output #1 to toggle mode with a shorter code (3 digits)
(b) Saves the setting (the lock will beep twice and the "MAINS" LED will flash two times)
Function in normal mode:
For example, if you entered code "43" to enable toggle mode, and the user code for output #1 is
"62581", you can activate the output as follows:
To enable output #1, enter the first three digits of a user code. The full user code is required to
disable the output.
You can also activate/disable the output using the full superuser code.
98
Activate output #1
Disable output #1