F) Relay Activation Tone; G) Code Lock Function Tones; H) Function Led Settings; Programming - Renkforce 1582597 Bedienungsanleitung

f) Relay activation tone

The code lock beeps when the relay is activated. These notification tones can be disabled or
configured to suit your needs. By default, the code lock is set to beep when the relay is opened.
To change these settings, refer to "p) Setting the relay activation tone".

g) Code lock function tones

The code lock uses notification tones to indicate keypad entries and programming commands.
These tones can be configured to suit your needs. By default, the code lock beeps when you
press a key and confirm a function. To change these settings, refer to "q) Configuring the
function notification tone settings" in section 10 ("Programming").
When you use the master code to enter programming mode, the notification tones
are enabled for the duration of the programming, even if they have been disabled (to
confirm a keypad entry).
When you enter a user code in either entry mode (automatic or manual), the code lock
will beep when the door opens (the yellow and green LED will turn on briefly), even if
notification tones are disabled.

h) Function LED settings

By default, the yellow function LED flashes in standby mode. This setting can be disabled. All
other indicator settings (e.g. the green LED used to indicate that the door was opened) will
function as usual. To configure these settings, refer to "r) Configuring the LED indicator settings"
in section 10 ("Programming").

10. Programming

Do not disconnect the power supply while programming the code lock, otherwise the
settings may not be saved.

a) Enabling programming mode

Program the code lock at the installation location/before mounting to reduce the total installation
time.
To enable programming mode, enter the master code, and then press the * key (star key) to
confirm your entry. The default master code is "0000".
Important – if you have already programmed another master code, use the new
master code.
55