Signal Sounds And Led Displays - Renkforce IP65 Bedienungsanleitung

9. Signal Sounds and LED Displays

The signal sounds (beeps) and the LED (1) at the upper left of the code lock display the following
functions/operating conditions:
Operating mode/status
Programming mode is active
Confirmation at push of a button
User code or transponder correct
User code or transponder incorrect;
programming taking too long
Activation delay for input of the
DAP code
Activation of output #1
Code lock ready (waiting for input of
an access code or a transponder)
Reset; deleting all user codes
User code (or transponder) already in
the memory
Connection to external decoder
defective
Data of the integrated real-time clock
defective or lost after power outage
(*) The signal sounds can be switched on or off via programming code 71.
(**) The signal sound can be switched on or off via programming code 72.
(***) The LED signal can be switched on or off via programming code 73.
The left LED (1) is lit red when output #1 is locked.
The right LED (2) is lit green when output #1 is active.
76
Beeps (*)
---
1x brief beep
2x brief beeps
5x brief beeps
Brief beeps for 1 minute
1x long beep (**)
---
---
1x long beep
1x brief beep
every 5 seconds
3x brief beeps
every 5 seconds
LED
LED is permanently lit
1x brief flash
2x brief flashes
5x brief flashes
Brief flashes for 1 minute
---
LED flashes 1x per second (***)
Quick flashing
for up to 2.5 minutes
---
---