Programming; A) Universal Access, Resetting Codes - Renkforce 751074 Bedienungsanleitung

Output 2 is not needed here and can be used for other purposes (e.g. for an alarm
system).
Check once more that all the cabling is correct.
Now connect the main power supply to your code lock.
After about 2 seconds the yellow "MAIN" LED begins to blink. Now, close the cover
carefully again.
If this does not be the case or any other type of fault occur, immediately switch off
the power supply and double-check all your connections. Use the "Troubleshooting"
checklist towards the end of these Instructions.

9. Programming

You can now program your code lock to suit your personal requirements. This chapter
explains all the programming possibilities.
You should not take longer than 10 seconds between each keypad operation,
otherwise the previous keypad entries will be deleted.

a) Universal access, resetting codes

If you have forgotten your master code, or it no longer seems to function, then perform
the following steps.
• Remove your code lock from the power supply
• Move jumper DAP (8) from "OFF" to "ON"
• Reconnect the main power supply to your code lock (a permanent beep sounds)
• Now move jumper DAP (8) from "ON" to "OFF" (the beep tone mutes) The master
code has now been reset to "0000".
• You are now in programming mode and can make all required settings. Please take
these settings from the chapter "Programming explanation" in this instruction.
51