OEG KSF-Pro Handbuch Seite 45

Para- Parameter name
meter
S1.12 OUTPUT R9 FUNCTION
S1.13 SENSOR T1 CALIBRA-
TION
S1.14 SENSOR T2 CALIBRA-
TION
S1.15 SENSOR T3 CALIBRA-
TION
S1.16 SENSOR T4 CALIBRA-
TION
S1.17 SENSOR T5 CALIBRA-
TION
S1.18 SENSOR T6 CALIBRA-
TION
S1.19 SENSOR T7 CALIBRA-
TION
S1.20
SENSOR T8 CALIBRA-
TION
Service settings for the first heating circuit:
Para- Parameter name
meter
S2.1 INFLUENCE OF ROOM
TEMP. DEVIATION
S2.2 INFLUENCE OF ROOM
SENSOR T1 OR T8
Parameter description
Setting of output R9 operation mode.
1 - KTF, output is used for solar differential thermostat.
2 - KF2, output is used for solid fuel boiler differential
thermostat.
3 - output is used for d. h.w. circulation
4 - output is used for d. h. w. warming with electric heater
5 - output is used to control boiler return temperature (bypass
pump), set also S1.4=9 (for sensor T1) or S1.5=12 (for sensor
T8).
6 - output is used to control boiler primary pump
7 - output is used to control heat pump
Correction of displayed measured temperature for sensor T1.
Correction of displayed measured temperature for sensor T2.
Correction of displayed measured temperature for sensor T3.
Correction of displayed measured temperature for sensor T4.
Correction of displayed measured temperature for sensor T5.
Correction of displayed measured temperature for sensor T6.
Correction of displayed measured temperature for sensor T7.
Correction of displayed measured temperature for sensor T8.
Parameter description
Set the influence of room temperature deviation. Lower value
means lower influence, higher value means higher influence.
Setting of room sensor T1 or T8 influence on the operation of
first circuit.
1- automatic room sensor influence
- room sensor has no influence if room unit DD2+ is
connected
- room sensor has influence if room unit DD2+ isn't
connected
2- room sensor has influence
3- room sensor has no influence
This setting has affect only if S1.4=1 (for sensor T1) or S1.5=4
(for sensor T8).
45
Setting Default
range setting
1- KTF
2- KF2
3- D. H. W.
CIRC.
4- EL. HEA-
TER
0
5- BYPASS
PUMP
6- PRIMARY
PUMP
7- HEAT
PUMP
-5 ÷ 5 K
0
-5 ÷ 5 K
0
-5 ÷ 5 K
0
-5 ÷ 5 K
0
-5 ÷ 5 K
0
-5 ÷ 5 K
0
-5 ÷ 5 K
0
-5 ÷ 5 K
0
Setting Default
range setting
0,0 ÷ 3,0
1
1- AUTO
2- YES
3- NO
1
Service setting manual