OEG KSF-Pro Handbuch Seite 10

STEP 2 - HYDRAULIC SCHEME SETUP
Later you can change the selected hydraulic scheme with service parameter
S1.1.
STEP 3 - SETUP OF HEATING CURVE STEEPNESS FOR THE FIRST CIRCUIT
Later you can change the heating curve steepness with parameter P2.1. The
meaning of heating curve steepness is detaily described on page 39.
User manual
Select a hydraulic scheme for controller operation.
Move between schemes with buttons
Confirm the selected scheme by pressing
All schemes with mixing heating circuit
are available for radiators and floor/
wall heating.
The controller requires a confirmation of language
selection with the
In case you choose the wrong scheme, return to
scheme selection with the
Set the heating curve steepness for the first heating
circuit.
Change the value with buttons
Confirm the selected value by pressing
The controller requires a confirmation of the set heat-
ing curve steepness with the
In case you choose the wrong heating curve steep-
ness, return to heating curve steepness selection
with the button.
10
and
button.
button.
and .
button.
.
.
.