O) Selecting The Operating Mode For The Door Opener Button - Sygonix 1559246 Bedienungsanleitung

o) Selecting the operating mode for the door opener button

By default, pressing the door opener button (if connected) activates output #1 on the combina-
tion lock.
In some scenarios you may wish for there to be a delay between pressing the button and activat-
ing output #1 (for the connected door lock). For example, configuring a delay can prevent people
from leaving a room quickly.
The combination lock will beep during the delay to indicate that the door opener button has
been pressed.
Important!
When you set a delay, people will not be able to leave the room quickly. This may
constitute a safety hazard in some scenarios (e.g. in the event of a fire).
Before setting a delay (disabled by default), ensure that you comply with all applicable
safety regulations in your country (e.g. the requirement to designate a second escape
route).
If in doubt, do not set a delay.
Proceed as follows:
• The combination lock must be in programming mode (see section 12. a) for details).
• Enter programming code
• Select the desired function for output #1 (e.g. a connected door opener).
B riefly press the door opener button to release the door opener. To set the activation
time for the door opener (output #1), refer to the instructions in section 12 h).
The door opener will be activated approximately 5 seconds after you press the door
opener button. The combination lock will beep during this period.
The door opener will be activated approximately 10 seconds after you press the door
opener button. The combination lock will beep during this period.
Hold down the door opener button for 5 seconds to activate the door opener. The
combination lock will beep during this period.
Hold down the door opener button for 10 seconds to activate the door opener. The
combination lock will beep during this period.
.
101