D) Superuser Code - Sygonix 1559246 Bedienungsanleitung

d) Superuser code

The superuser code allows you to manually enable outputs #1 and #2. It is not affected by time
restrictions or system locks.
It can also be used to permanently enable output #1.
Saving the superuser code:
• The combination lock must be in programming mode (see section 12. a) for details).
• Enter programming code
• Enter a 4 to 8 digit code (e.g.
Important!
When the "Auto entry" feature is enabled (see section 12. m), all codes must be the
same length (e.g. if the master code is 5 digits, the user codes must also be 5 digits).
• Press the button to confirm your entry.
• The combination lock will beep twice and the middle LED will flash two times to indicate that
the superuser code has been saved.
The existing superuser code will be overwritten.
Deleting the superuser code:
• The combination lock must be in programming mode (see section 12. a) for details).
• Enter programming code
• Press the button to confirm your entry. The combination lock will beep twice and the mid-
dle LED will flash two times to indicate that the superuser code has been deleted.
Function 1: Enabling/disabling output #1 and #2
Enter the superuser code like a standard user code. The corresponding output will be enabled/
disabled (the superuser code will reset the enabled output if you have set a very long timer (see
section 12. h) for details).
Example: The Superuser-Code was set to "6789":
80
.
.
Enable/disable output #1
Enable/disable output #2
).