Programming; Exiting Programming Mode - Sygonix 1559246 Bedienungsanleitung

12. Programming

Do not disconnect the combination lock from the power supply when programming the
device, as this may damage existing data and settings.
The combination lock codes (e.g. the master code, user codes, and superuser code) can be
4 to 8 digits long.
When the "Auto entry" feature is enabled (see section 12. m), codes do not have to be
confirmed with the
master code is 5 digits, the user codes must also be 5 digits).
Each code must be unique. For example, the master code cannot be the same as the user code.
The combination lock will beep if you attempt to set the same code twice.
The pause between each button press must not exceed 10 seconds, otherwise the combination
lock will beep 5 times to indicate an error.
a) Exiting programming mode
• The middle LED on the top of the combination lock should blink slowly to indicate that the
lock is in normal mode.
• Enter the master code (factory default = "0000") and confirm your entry by pressing the
button.
For security reasons, the master code must be changed when you set up the lock (see
section 12. c) for details).
If you forget the master code, follow the instructions in section 11 to enable program-
ming mode. You can then configure a new master code (see section 12. d) for details).
If the master code is correct, the combination lock will beep twice and enter programming
mode. The middle LED will stay constant.
• Y ou can now configure the desired settings (refer to the instructions on the following pages
for details).
• Press the button to exit programming mode.
The combination lock will beep twice to indicate that it is in normal mode and the middle LED
will flash slowly.
78
button, therefore all codes must be the same length (e.g. if the