Restoring Factory Settings; Setting The Master Code - Sygonix 1559246 Bedienungsanleitung

b) Restoring factory settings
All existing settings and programs can be deleted using a special code.
The master code will not be reset.
Proceed as follows:
• The combination lock must be in programming mode (see section 12. a) for details).
• Enter
• Press the button to confirm your entry.
• The combination lock will beep and the middle LED will flash quickly to indicate that the set-
tings are being deleted.
This process may take several seconds if there is a large amount of data.
• When the data has been deleted, the combination lock will beep twice and the middle LED
will stay constant to indicate that programming mode is enabled.
• All settings and programs have now been reset to the factory settings (except the master
code).
c) Setting the master code
Important!
When the "Auto entry" feature is enabled (see section 12. m), all codes must be the
same length (e.g. if the master code is 5 digits, the user codes must also be 5 digits).
The master code is used to enable programming mode (see section 12. a) for details). It cannot
be used to activate either of the outputs.
Proceed as follows:
• The combination lock must be in programming mode (see section 12. a) for details).
• Enter programing code
• Enter the new master code (e.g.
• Press the button to confirm your entry. The combination lock will beep twice and the
middle LED will flash two times to indicate that the master code has been saved (the old
code will be overwritten).
Write down the new master code and store it in a safe place. If you forget the master
code, follow the instructions in section 11 to enable programming mode and set a new
code.
.
.
).
79