P) Configuring An Open Door Warning Tone - Sygonix 1559246 Bedienungsanleitung

p) Configuring an open door warning tone

You can set the combination lock to beep when the door is not closed within a certain time
period.
Before using this feature, ensure that you have connected a door sensor (with NC
contact) to the corresponding input on the combination lock (see instructions on termi-
nal 14 in section 6).
Proceed as follows:
• The combination lock must be in programming mode (see section 12. a) for details).
• Enter programming code
• Select the desired function:
.....
• Press the button to confirm your entry. The combination lock will beep twice and the mid-
dle LED will flash two times to indicate that the setting has been saved.
The warning tone will stop when the door sensor registers that the door has been
closed.
Example: Warning tone activated when the door has been open for 30 seconds
(a) (b) (c)
(a) Programming code
(b) 30 second delay
(c) Saves the setting (the lock will beep twice and the middle LED will flash two times)
For example, if someone opens the door with a valid user code and holds the door
open with an object, the combination lock will give off a warning tone after 30 seconds.
The warning tone will stop when the door is closed.
.
Warning tone off
Activation of the warning tone after 1.....999 seconds
103