Beeps And Led Indicators - Sygonix 1559246 Bedienungsanleitung

10. Beeps and LED indicators

The three LEDs on the front of the combination lock (see diagram in section 7, positions A, B
and C) have the following functions:
Red LED (A)
Turns on when output #2 is activated.
Amber LED (B)
Confirms button presses and indicates functions together with the built-in buzzer:
Status
Normal mode
Programming mode is enabled
Button press
Correct code
Wrong code
DAP jumper was not reset to the
default position ("OFF")
Output is activated
* The beep tones for entering a code can be disabled (program code 83).
** The long beep tone (indicating an active output) can also be disabled (program
code 81).
Green/red LED (C)
The LED turns green when output #1 is activated.
If output #1 is locked, the LED turns red.
76
Beeps *
-
-
1x short beep
2x short beeps
5x short beeps
Constant short beeps
1x long beep **
Status LED
Flashes once every two
seconds
LED stays constant
1x short flash
2x short flashes
5x short flashes
Constant short flashes
LED turns on for one
second