Operation - Sygonix 1559246 Bedienungsanleitung

9. Operation

• Once you have finished mounting the product (see section 7 for details), turn on the power
supply.
• The middle LED (B) on the top of the combination lock will start to flash slowly.
• The combination lock is now ready to program (see section 12 for details).
The master code is required to program the combination lock. By default, the master
code is set to "0000". Always change the master code before using the combination
lock.
Important!
If you forget the master code, follow the instructions in section 11.
Warning!
The combination lock codes (including the master code, user codes, superuser code
and visitor codes) can be 4 to 8 digits long.
When "Auto entry" mode is enabled (see section 12. m), codes do not have to be
confirmed with the
master code is 5 digits, the user codes must also be 5 digits).
Data and settings are not affected by power cuts. However, visitor codes will be auto-
matically deleted for security reasons.
button, therefore all codes must be the same length (e.g. if the
75