3M ROLLGLISS R350 Gebrauchsanleitung Seite 13

5.0 INSPECTION
;
Product that has been removed from service must be sent to an authorized service center for thorough inspection,
maintenance, and recertification.
;
After equipment has been removed from service, it may not be returned to service until a Competent Person confirms in
writing that it is acceptable to do so.
5.1 INSPECTION FREQUENCY: The product shall be inspected before each use by a user and, additionally, by a Competent
Person other than the user at intervals of no longer than one year. A higher frequency of equipment use and harsher
conditions may require increasing the frequency of Competent Person inspections. The frequency of these inspections
should be determined by the Competent Person per the specific conditions of the worksite.
5.2 INSPECTION PROCEDURES: Inspect this product per the procedures listed in the "Inspection and Maintenance Log".
Documentation of each inspection should be maintained by the owner of this equipment. An inspection and maintenance
log should be placed near the product or be otherwise easily accessible to users. It is recommended that the product is
marked with the date of next or last inspection.
5.3 DEFECTS: If the product cannot be returned to service because of an existing defect or unsafe condition, then the
product must be either destroyed or sent to 3M or a 3M-authorized service center for repair.
;
If the capacity limits for descent or lifting applications have been exceeded, then the product must be removed from
service and sent for repair. This includes the maximum number of uses as well as the total distance traveled. See Table
1 for more information.
;
Product should be destroyed when repair is not feasible.
5.4 PRODUCT LIFE: The functional life of the product is determined by work conditions and maintenance. As long as the
product passes inspection criteria, it may remain in service.
5.5 DISPOSAL: Cut or otherwise disable the lifeline, then dispose of the product appropriately.
5.6 RECERTIFICATION: This product must be recertified for service at least once every five years. If the product has been
removed from service, then it must be recertified before returning to service. Recertification must be completed by an
authorized service center.
6.0 MAINTENANCE, STORAGE, AND REPAIR
;
Equipment that is in need of maintenance or scheduled for maintenance should be tagged "DO NOT USE". These
equipment tags should not be removed until maintenance is performed.
6.1 CLEANING: Periodically clean the lifeline and the exterior of the product with water and a mild soap solution. Rinse the
product thoroughly and air dry. Clean labels as necessary. For more information, please refer to the technical bulletin on
our website: https://www.3M.com/FallProtection/Mechanical-Device-Cleaning
6.2 REPAIR: Only 3M or parties authorized in writing by 3M may make repairs to this equipment. Do not attempt to
disassemble the product or lubricate any parts.
6.3 STORAGE AND TRANSPORT: When not in use, store and transport the product in a cool, dry, clean environment out of
direct sunlight. Avoid areas where chemical vapors may exist. Thoroughly inspect the product after extended storage.
;
Product installed at a workstation and left in place between inspections should be adequately protected from
environmental conditions.
Figure 7B - Tripod Applications
H
+
-
+
L
-
C
13
D
S