Herunterladen Diese Seite drucken

Scheppach SG3100 Original Bedienungsanleitung Seite 29

Vorschau ausblenden Andere Handbücher für SG3100:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
When re-commissioning after a long period of
storage
1.
Change the engine oil.
2.
Fill with fresh petrol before starting the motor after
the storage period.
If the engine is not used for more than one month,
changes to the petrol quality may result in difficulties
starting the engine or in other issues. To prevent this,
loosen the carburettor's drain screw and allow the
petrol to run out. Also open the fuel valve so that the
petrol drains from the tank.
Cleaning:
• Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible. Rub
the device clean with a clean cloth or blow it off with
compressed air at low pressure.
• We recommend that you clean the device directly
after every use.
• Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the device. Make sure that no water can
penetrate the device interior. Water entering a power
tool will increase the risk of electric shock.
Important note in the case of repairs:
When returning the device for repair, please ensure for
safety reasons that it is free of oil and fuel when it is
sent to the service centre.
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*:Spark plug
* may not be included in the scope of supply!
Spare parts and accessories can be obtained from
our service centre. To do this, scan the QR code on
the cover page.
12. Disposal and recycling
The device is supplied in packaging to avoid
transport damages. This packaging is raw ma-
terial and can thus be used again or can be
reintegrated into the raw material cycle.
The device and its accessories are made of
different materials, such as metals and plas-
tics. Take defective components to special waste dis-
posal sites. Check with your specialist dealer or munic-
ipal administration!
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
handed over at the intended collection point. This can
be done, for example, by returning it when purchasing
a similar product or delivering it to an authorised collec-
tion point for the recycling of old electrical and electron-
ic devices. Improper handling of waste equipment may
have negative consequences for the environment and
human health due to potentially hazardous substances
that are often contained in electrical and electronic
equipment. By properly disposing of this product, you
are also contributing to the effective use of natural re-
sources. You can obtain information on collection
points for waste equipment from your municipal admin-
istration, public waste disposal authority, an authorised
body for the disposal of waste electrical and electronic
equipment or your waste disposal company.
www.scheppach.com
GB | 29

Werbung

loading

Diese Anleitung auch für:

5906213901