Werbung
E360
Name already exists or not allowed
E361
Names must be at least 2 characters long and contain only characters: a-zA-Z0-9_
E362
Storage region is full
E363
Setting name not found
E364
Setting is invalid
E600
ROI begin must be less than ROI end
E606
Minimal value must be less than maximal value
E610
Encoder triggering: The minimum value has to be less than the maximum value
E611
Encoder's start value must be less than the maximum value
E612
Encoder triggering: The step size is greater than the difference between minimum and maximum
E615
Synchronisation as slave and triggering at level or edge are not possible at the same time
E616
Software triggering is not active
E621
The entry already exists
E626
Dataset not available
E628
The value of the lower limit is greater than the upper limit
E640
LightCorr check failed
W316
Sensor changes to fieldbus/recovery mode
W526
Output signal selection modified by the system
W530
The IP settings have been changed
W580
Dependent setting parameters were also modified
W602
Lightcorrwarning
optoCONTROL 2700
ASCII Kommunikation
Seite 97
Werbung
