Chopard L.U.C 1963 Heritage Chronograph Bedienungsanleitung Seite 15

28 ENGLISH
clockwise rotations of the crown. This push it in at the time signal once the hour
is equivalent to a power reserve of and minute hands have been adjusted.
approximately 35 hours.
Your watch is supplied with a corrector Adjusting the date
tool enabling you to precisely adjust the Adjust the date using pusher [K]. Each
date, month, four­year leap­year cycle, press moves the date one day forward.
day and moon phase.
Adjusting the month and the
four-year leap-year cycle
ADJUSTMENTS
Adjust the month and the four­year leap­
year cycle using pusher [L]. Each press
Crown in Position 1 – normal
moves the month hand one month for­
running and manual winding ward and drives the year indicator.
Your watch runs normally when the
crown is in Position 1. Positioning the year indicator
– sector 1 facing the arrow for one year
Crown in Position 2 – setting the after a leap year (2021, 2025, etc.)
time – sector 2 facing the arrow for two years
Pull the crown out to Position 2 and after a leap year (2022, 2026, etc.)
turn until the desired time is displayed, – sector 3 facing the arrow for three
then push the crown back in to posi­ years after a leap year (2023, 2027, etc.)
tion 1. Since the date change occurs at – sector 4 facing the arrow for a leap year:
midnight, be careful to distinguish mid­ any year divisible by 4, but not divisible
night from midday when adjusting your by 100, is a leap year (2024, 2028, etc.)*
timepiece. This model is equipped with
a stop­seconds feature, which stops
the mechanism when the crown is in
Position 2. To adjust your watch to the
second, pull the crown out to position 2
when the second hand is at zero and
Adjusting the day of the week
Adjust the day using pusher [I]. Each
press moves the day of the week forward.
Adjusting the moon phases
Adjust the moon phases using pusher [J].
– place the disc in the full­moon position.
– identify the date of the last full moon
using the full moon calendar on
page 326.
– count the number of days elapsed
since this date.
– press the pusher as many times as
days elapsed.
* However, years that are divisible by 100 are
only leap years if their number is also divisible
by 400: 2000 was thus a leap year, but 1700,
1800 and 1900 were not.
REMARKS AND WARNINGS
– After each adjustment, the crown must
always be pushed back and screwed
in (depending on the model) in order to
guarantee its water­resistance.
– These operations must not under
any circumstances be performed
underwater, since this might damage
the movement.
– These models are set by our watch­
makers for the Northern hemisphere.
On request, the display can be set
to the Southern hemisphere. In this
case, kindly contact your official
Chopard retailer.
– Moon­phase correction is not opera­
tional between 8.30 am and 9.30 am.
The moon jump takes place at
10.15 am.
– Never use a pen or any other instru­
ment other than that supplied, as this
could damage the watch.
L.U.C LUNAR ONE 29