Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1
2
3
4
//gooo
234_
0
,,_® @.......
®,®. ®,_,o
DENON
--2,3,4
NOTES:
• An English caption
decoder is required
to display
English
captions,
• DVDs with
caption
signals
are indicated
by the
D,
_J,
r_l,
mark,
English captions
cannot be displayed when playing DVDs
which do not contain caption signals.
• The
characters
in which
the
captions
are
displayed
(capital letters,
small letters,
italics, etc,) depend
on the
DVD and cannot be selected
with this unit.
--
See page 40,
Use the
_.
and v
cursor buttons
to select the
desired setting,
then press the ENTER button,
• CAPTIONS
Use this to
set whether
or not to display
the
closed captions
recorded
on DVDs,
=_TO exit the other
setup mode
Use the ,_ and v
cursor buttons to select "DVD
SETUP MENU",
then
press the ENTER button,
• The screen returns to as it was in step 2,
Remote control
unit
Remote control
unit
Use the
_.
and v
cursor buttons
to select the
desired setting,
then press the ENTER button,
==When "CAPTIONS"
is selected:
• OFF (Factory default)
Select this when you do not want
to display the
captions
on
the
screen
when
playing
DVDs
containing
English captions.
• ON
Select this to display
the captions
on the screen
when playing DVDs containing
English captions.
To exit the captions
mode
Press the ENTER button,
you can go back to the
previous
screen,
• The screen returns to as it was in step 2,
k
'..
Remotecontrol unit
Remote control
unit
_]
LAST FUNCTION
MEMORY
• This unit is equipped
with a last function
memory which stores the input and output setting conditions
as they were immediately
before the power
is switched
off,
This function
eliminates
the need to perform
complicated
resettings
when the power
is switched
on,
• The unit is also equipped
with a back-up memory,
This function
provides memory
storage when the power switch
is off and with
the power cord disconnected,
INITIALIZATION
OF THE MICROPROCESSOR
When
the indication
of the display
is not normal
or when the operation
of the unit does not shows
the reasonable
result, the
initialization
of the microprocessor
is required
by the following
procedure,
Press the power
button to set the
standby
mode,
then
unplug
the
set's
power
cord
from
the wall
power
outlet,
ON
/ STANDBY
_
Green
1
22
Hold the following
PLAY (1_) button
and STOP
(m)
button,
and plug the AC cord into the outlet.
Check that the entire display is flashing with an interval
of about
1 second, and release your fingers
from the 2
buttons
and the microprocessor
will be initialized.
NOTES:
• If step 3 does not work, start over from step 1,
• If the microprocessor
is reset,
all the buttons
and the
setup settings
are reset to the factory default values,
45
Werbung
Inhaltsverzeichnis
