Denon ADV-700 Bedienungsanleitung Seite 34

• There are many music distribution sites on the intemet from which music files in MP3 format can be downloaded. Music
downloaded as instructed on the site and written onto a CD-R/RW disc can be played on the ADV-700.
If music recorded on commercially available music CDs is converted on a computer into MP3 files using an MP3 encoder
(conversion software), the data on a 12 cm CD is reduced into about 1/10 the amount of the original data, Thus, when written
in MP3 format, the data of about 10 music CDs can fit onto a single CD-R/RW disc, A single CD-R/RW disc can contain over
100 tracks,
* Values when 5-minute tracks are converted with a standard bit rate of 128 kbps into MP3 files and using a CD-R/RW disc
with a capacity of 650 MB.
Before operating the remote control unit!
" Be sure to set the DVD mode using
the remote control mode selector
buttons.
1
1 3
Load the CD-R/RW disc on which the MP3 format music
files have been written into this unit. (See page 17.)
• When the disc is loaded in the ADV-700, the disc
information screen appears.
• If there are multiple folders, proceed to step 2.
• If there are no folders on the disc (if the disc only
contains MP3 files), proceed to step 3.
All the folders recorded on the disc are displayed.
(The folders are not displayed by layer,)
0000
m2,3
_!gi:i ,}bx¸¸¸¸¸¸:¸
I BSg}}a_FOBMAT_0N I DENON
Pl_YMI_E : NORMAL
SINGLE EL_ED : ..:..
L_ELE_T:YA41 1_ _ []_t$10N_B_IaI_N_
Use the A and V cursor buttons to select the
folder containing the file(s) you
want to play, then press the ENTER button.
To change the folder
Use the A cursor button to select "ROOT" at the
upper right of the screen, then press
the ENTER button. The screen in step 1 reappears.
Select the desired folder.
Remote control unit
Remotecontrol unit
i
!{ii
PLAYM0_ :NORMAL
3
Use the A and V ursor buttons to select the MP3
file you want to play, then press the PLAY (1_) button or
ENTER button.
• Playback starts.
:_ The display can be switched between the single
elapsed time and the single remaining time by
pressing the DISPLAY button.
:_ Programmed playback is not possible with MP3
discs.
To change the MP3 file
Press the STOP button, then use the _. and V
cursor buttons to reselect the desired MP3 file.
TO set the random play mode
In the stop mode, press the RANDOM button.
Then press the PLAY (1_) button or ENTER button.
To set the repeat mode
The repeat mode changes each time the REPEAT
button is pressed.
NORMAL -e TRACK REPEAT -e FOLDER REPEAT
t ]
To return to the initial disc information screen
Press the STOP (11) button, use the A cursor
button to select "ROOT" at the upper right of the
screen, then press the ENTER button.
The screen in step 1 reappears.
Remote control unit
Main unit Remote control unit
Remote control unit
E _SC IG_0RMAn0G j DENON
PLAY MOB_ _I,_RMAL
SINGLE E LAPSED : 00:01
NOTES:
• The ADVW00 is compatible with the "MPEG-1 Audio Layer 3" standards (sampling frequency of 32, 44.1 or 48 kHz). It is
not compatible with such other standards as "MPEG-2 Audio Layer 3", "MPEG-2.5 Audio Layer 3", MP1, MP2, etc.
• It may not be possible to play some CD-R/RW discs due to disc properties, dirt, warping, etc.
• The digital signals output when playing MP3 files are MP3 signals converted into PCM, regardless of whether the audio
output presenting is set to "normal" or "PCM conversion". The signals are output with the same sampling frequency as
that of the music source.
• In general, the higher an MP3 file's bit rate, the better the sound quality. On the ADV-700, we recommend using MP3 files
recorded with bit rates of 128 kbps or greater.
• MP3 files may not be played in the expected order, since the writing software may change the position of the folders and
the order of the files when writing them on the CD-R/RW.
• Manual search and programmed playback are not possible with MP3 discs.
• When writing MP3 files on CD-R/RW discs, select "1SO9660 level 1" as the writing software format. This may not be
possible with some types of writing software. For details, refer to the writing software's usage instructions.
• With the ADV-700 it is possible to display folder names and file names on the screen like titles. The ADV-700 can display
up to 11 characters, consisting of numbers, capital letters, and the "" (underscore) mark.
• If recorded in a format other than "1SO9660 level 1", normal display and playback may not be possible. In addition, folder
and file names including other symbols will not be displayed properly.
• Be sure to add the extension ".MP3" to MP3 files. Files cannot be played if they have any extension other than ".MP3"
or if they have no extension. (with Macintosh computers, MP3 files can be played by adding the extension ".MP3" after
the file name consisting of up to 8 capital or numbers and recording the files on the CD-R/RW.)
• Do not apply stickers, tape, etc., to either the label side or the signal side of CD-R/RW discs. If adhesive gets on the surface
of a disc, the disc may get stuck inside the ADV-700 and be impossible to eject.
• The ADV-700 is not compatible with packet write software.
• The ADV-700 is not compatible with ID3-Tag.
• The ADV-700 is not compatible with play lists.
34