F&P Airvo 3 Bedienungsanleitung Seite 27

English
A - 24 | Airvo 3 - USER MANUAL
5.6 Stopping therapy
3
When therapy is fi nished:
1. Remove the patient interface from your patient.
1 2. If oxygen is provided through the low-pressure oxygen inlet port on the
The Airvo 3 will automatically stop oxygen provided through the high-
pressure oxygen inlet port. You do not need to disconnect it.
1. Tap the STOP button to end therapy.
2. Review any warnings, then tap Yes to confi rm and enter standby mode
3. Turn the Airvo 3 off by holding down the Power button for
4. Tap Yes to power down the device.
The Airvo 3 must be cleaned and disinfected between patients. Follow the
reprocessing instructions if your patient has fi nished using the device.
2
2 secs
4
top of the Airvo 3, turn off and disconnect the oxygen supply.
Note
or No to continue therapy.
2 seconds.
Warning
To avoid burns, do not touch the heater-plate or the bottom of the
water chamber. The water in the chamber and the heater-plate beneath
the chamber become hot during use.
Turn off the low-pressure oxygen source before stopping therapy.
The oxygen fl ow must be turned off when the Airvo 3 is not delivering
therapy to ensure oxygen does not build up inside the device.