HBK U9C Montageanleitung Seite 52

S
Highest measured temperature of the PCB
S
Lowest measured temperature of the PCB
Index Subin­
(hex) dex
(hex)
0x00FD 0x00
0x1215 0x00
0x1214 0x00
0x0053 0x00
0x0055 0x00
0x0075 0x00
Reset functions
Four reset functions are available. All of the reset functions are triggered by a
corresponding system command (see section "System Command").
1. Device Reset
The sensor restarts. Please note that the minimum and maximum values, as well as all of
the statistical information (peak-peak) will be lost. All of the other settings and
parameters are retained.
2. Application reset
The sensor does not restart. The following parameters are reset to the factory settings or
zero:
S
Filter settings
S
Switching points and hysteresis of the limit value switches
50
Data Type
Permissio­
ns
ReadOnly UIntegerT
ReadOnly Float32T
Read and UInteger32T
Write
ReadOnly Float32T
ReadOnly Float32T
ReadOnly Float32T
Data Description
Size
bytes
2 IO-Link
reconnect
counter
4 Operating
hours since
startup
4 Number of
restarts of the
measurement
chain
4 Current temper­
ature of the
electronics
4 Current temper­
ature of the
microprocessor
4 Current supply
voltage
Description
Number of IO-
LINK connec­
tion interrup­
tions since
start-up
In hours, as
floating-com­
ma number
Can be set to
zero by the
user.
Board Temp
in degC
Core Temp in
degC
Supply
Voltage in V
ELECTRICAL CONNECTION
U9C