Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
You will find the diameters of the knuckle eyes and shafts and their recommended
tolerances in the table below.
Knuckle eyes
1-Z8/100kg/ZGW
1-U9/20kg/ZGWR
1-U9a/50kg/ZGW
Tab. 7.2
Recommended fitting sizes/tolerances for shaft and hole
Fig. 7.3
Example diagram of installation with knuckle eye
CAUTION
If a shaft with an overly small diameter is used, the bearing of the knuckle eye will be
subjected to linear load. This subjects the inner bearing shell to excessive load, which can
lead to damage and, if forces are high, can cause the knuckle eye bearing to break.
Select the shaft as recommended in the mounting instructions.
18
Nominal
Hole fitting
diameter
5
10
16
Threaded connector for mounting
on force transducers
Recommended shaft
size
H7
Customer's construction
Customer's shaft holder
Shaft
Play based on recommended fitting
size, see Tab. 7.2, page 18
fitting size
g6
MECHANICAL INSTALLATION
U9C
Werbung
Inhaltsverzeichnis
