HBK U9C Montageanleitung Seite 11

- SUB­D connector, 15-pin: 15-pin connector for connection to numerous amplifier
systems, e.g. MGCplus, Scout, MP85, etc.
- SUB­HD connector: A 15-pin plug for connection to appropriate amplifier systems,
e.g. the HBK QuantumX system
- 3106 PEMV connector (Greenline): For connection to appropriate amplifier
systems, e.g. MGCplus with AP03.
- Free ends: Transducer delivered without plugs.
- The force transducer can be ordered with a permanently connected amplifier
electronics module which converts the output signal of the force transducer into a
0 V to 10 V signal. This option is only available with 1.5 m and 3 m cable lengths.
- The force transducer can also be ordered with a permanently connected amplifier
electronics module which converts the output signal of the force transducer into a
4 ... 20 mA signal. This option is only available with 1.5 m and 3 m cable lengths.
3. TEDS
You can order the force transducer with transducer identification ("TEDS").
TEDS (Transducer Electronic Data Sheet) allows you to store the transducer data
(characteristic values) in a chip that can be read out by a connected measuring device
(with an appropriate amplifier). HBK records the TEDS data at the time of delivery so
that no parameterization of the amplifier is necessary.
TEDS can only be fitted in the plug of the U9C, therefore it is not possible to equip the
"free cable ends" version with TEDS. The versions with permanently connected
amplifier electronics cannot be connected with the TEDS option.
U9C
SCOPE OF SUPPLY, ACCESSORIES, AND VARIANTS
9