Statistical Functions (Statistics) - HBK U9C Montageanleitung

Index Sub­
(hex) index
(hex)
0x0DAD 0x00
0x0DAE 0x00

8.3.10 Statistical functions (statistics)

It is important to note, that the internal sample rate is used to evaluate the signal of the
following functions. As the electronics work with 40,000 measurement points, even very
short peak loads are recorded. Please note, any low-pass filters that you set, can quickly
suppress peak loads which will then not be recorded in the maximum value buffer.
All of the following functions are executed on a continuous basis and are not saved
permanently. This means that a power failure will be the same as a reset.
Maximum force, minimum force, peak-to-peak memory
The following functions do not save the values permanently.
Contents of
maximum
value buffer
Fig. 8.5 Function of maximum value buffer
U9C
ELECTRICAL CONNECTION
Permissions Data
Type
ReadWrite UIntegerT 1
ReadWrite UIntegerT 1
Data Description
Size
bytes
DO/DI (I/Q)
pin mode
C/Q SIO pin
mode
Description
Selection of the
switching channel
that should be
assigned to PIN 2
Selection of the
switching channel
that should be
assigned to PIN 4
41