Disposal; Maintenance - Wilo EMUport FTS MG Serie Einbau- Und Betriebsanleitung

English
Once this work has been completed, the pump
station can be installed as described in the
" I nstallation" section and connected to the
electricity supply by the electrician.
The pump station must be switched on as
d escribed in the "Start-up" section.
The pump station may only be restarted if it is
in perfect condition and ready for operation.

7.4. Disposal

7.4.1. Lubricants
Oils and lubricants must be collected in appro-
priate containers and properly disposed of in
terms of EC Directive 75/439/EEC as well as in
compliance with the provisions of sections 5a
and 5b of the German Waste Act or the applicable
local laws.
7.4.2. Protective clothing
Protective clothing worn for cleaning and main-
tenance work is to be disposed of in accordance
with the German Waste Code TA 524 02 and EC
Directive 91/689/EEC.
7.4.3. Waste water pump station
Proper disposal of this product avoids damage
to the environment and risks to personal health.
• Make use of the services or the advice of public or
private waste disposal companies for the disposal
of the product or parts of it.
• More information about proper disposal can be
obtained from the urban administration, the
waste disposal authorities or from the supplier
from whom the product was purchased.

8. Maintenance

Before performing maintenance or repair work,
switch off the pump station as described in the
"Final shutdown/disposal" section.
After completing maintenance or repair work,
the pump station must be connected a ccording
to the "Installation" section. The pump s tation
must be switched on as described in the
" S tart-up" section.
Maintenance or repair work must be carried out
by an authorized service center, Wilo customer
service or a qualified specialist.
Maintenance or repair work and/or construc-
tional changes that are not listed in this oper-
ating and maintenance manual or which could
impair explosion protection, may only be carried
out by the manufacturer or by authorized
service centers.
38
ELECTROCUTION hazard!
There is a risk of fatal electric shocks when
performing work on electrical devices. With all
maintenance or repair work, the pump station
or the particular components must be discon-
nected from the mains and secured against
being switched on again without permission.
Damage to the power supply cable may only
be rectified by a qualified electrician.
Note the following:
• This manual must be available to the maintenance
personnel and its instructions must be followed.
Only the repair and maintenance measures listed
here may be performed.
• All maintenance, inspection and cleaning work
on the pump station may only be carried out by
trained specialists exercising extreme care in
a safe workplace.
BEWARE of poisonous substances!
Waste water pump stations convey waste wa-
ter containing feces. Appropriate protective
clothing (e.g. gloves, goggles) must be worn.
Any contact with the waste water must be
disinfected immediately!
• The pump station, or the components to be
serviced, must be disconnected from the power
supply and secured against being switched on
again. It must be prevented from being switched
on inadvertently.
• When carrying out work in basins or containers,
the local protection measures must be observed
in all cases. A second person must be present for
safety reasons.
• Only hoisting gear that is in a technically perfect
condition, and load-carrying equipment that has
been officially approved and checked, may be
used for lowering and raising the pump station
or components. When lifting and lowering, make
sure that the pump station or components do not
become jammed. If, however, the pump station
or components do become jammed, the lifting
forces must not be greater than 1.2 x the weight.
The maximum load-carrying capacity must never
be exceeded.
Make sure that all fastening devices, ropes
and safety devices of the hoisting gear are
in a technically perfect condition. Work may
only commence if the hoisting gear has been
checked and found to be in perfect working
order. If it is not inspected, fatal injuries may
result.
• Electrical work on the system must be carried
out by an electrician. Defective fuses must be
replaced. Never attempt to repair them. Only fus-
es at the specified current and of the prescribed
type may be used.
• When working with flammable solvents and
cleaning agents, fires, naked lights and smoking
are prohibited.
WILO SE 02/2020 V4.1 DIN A4
MAINTENANCE