Disassembly With Integrated Drill Drift - Optimum OPTidrill DH 26GT Betriebsanleitung

4.16.2 Disassembly with integrated drill drift

ATTENTION!
The tool and/or the drill chuck will fall down. Hold the tool
drifting it out.
ATTENTION!
Do not try to expel the tool when it is in the intermediate position. This might cause
damages of the integrated drill drift or of the feed handle.
With the below described procedure the taper mandrel is being loosened from the
drilling spindle.

Move the sleeve as far down until the locking pin
diate position).

Move the locking pin
expulsion position).

Press the sleeve lever
The taper mandrel is pressed out of the drill spindle.

a) home position
Img.4-18: Functional diagram of the drill drift (sectional view)
EN
DH32GS
112
1
Img.4-17: Removal
so far, until the locking pin engages completely (Img. 4-10 (c)
1
with a fast and powerful movement upwards.
2
b) intermediate position
Translation of original instruction
2
3
or the drill chuck while
3
can be moved (Img. 4-10 (b) interme-
1
c) expulsion position
Version 1.2.9 - 2021-09-28