Inhaltsverzeichnis
Werbung
4.9.2
Disassembly with drill drift
The drill chuck and the taper mandrel are loosened from the drill spindle by means of a drill
drift.
WARNING!
Only disassemble the drill chuck if the geared upright drill is disconnected from the
electrical supply.
Switch off the geared upright drill on the main switch or disconnect the mains plug.
Move the drill sleeve down.
Turn the drilling spindle until the openings of the sleeve and of the drilling spindle are super-
imposed.
Loosen the taper mandrel of the drill chuck with the help of a drill drift.
Drill drift
Drill sleeve
Upper part of the
quick-action drill
chuck
Lower part of quick-
action drill chuck
Version 1.2.9 - 2021-09-28
Img.4-8: Disassembly with drill drift
Translation of original instruction
DH26GT | DH28GS
EN
103
Werbung
Inhaltsverzeichnis
