Inhaltsverzeichnis
Werbung
4.16.3 Fitting the drill chuck
The drill chuck or the tool is secured in the drill spindle against turning over by means of a form-
locking connection (driver).
A frictionally engaged connection keeps and centres the drill chuck or the drill in the drill spin-
dle.
Drill sleeve
Driver
Taper mandrel
Check or clean the conical seat in the drill spindle and on the taper mandrel of the tool or of
the quick-action drill chuck.
Press the taper mandrel into the drill spindle.
4.17
Coolant system
Coolant
Filler hole
Filling quantity
Coolant equipment on page 86
Version 1.2.9 - 2021-09-28
Img.4-19: Taper mandrel
Img.4-20: Filler hole
Translation of original instruction
DH32GS
EN
113
Werbung
Inhaltsverzeichnis
