Inhaltsverzeichnis
Werbung
materials or that not constitute a health hazard using a rotating filing-stripping tool that has a
number of grooves for collecting the filings.
If the geared drill is used in any way other than described above, modified without authoriza-
tion of Optimum Maschinen Germany GmbH, then the geared drill is being used improperly.
We will not be held liable for any damages resulting from any operation which is not in accord-
ance with the intended use.
We expressly point out that the guarantee or CE conformity will expire due to any constructive
technical or procedural changes which had not been performed by the company Optimum
Maschinen Germany GmbH.
It is also part of intended use that you
observe the limits of the geared drill,
the operating manual is observed,
the inspection and maintenance instructions are observed.
Technical data on page 85
WARNING!
Extremely severe injuries.
It is forbidden to make any modifications or alternations to the operation values of the
geared drill! They could endanger the personnel and cause damage to the geared drill.
1.4
Reasonably foreseeable misuses
Any other use other than that specified under "Intended use" or any use beyond the described
use shall be deemed as non-intended use and is not permissible.
Any other use has to be discussed with the manufacturer.
It is only allowed to process metal, cold and non-inflammable materials with the geared drill.
In order to avoid misuse, it is necessary to read and understand the operating instructions
before first commissioning.
Operators must be qualified.
1.4.1
Avoiding misuse
Use of suitable cutting tools.
Adapting the speed adjustment and feed to the material and workpiece.
Clamp workpieces firmly and vibration-free.
ATTENTION!
The workpiece is always to be fixed by a machine vice, jaw chuck or by another
appropriate clamping tool such as for the clamping claws.
WARNING!
Risk of injury caused by workpieces flying off.
Clamp the workpiece in the machine vice. Make sure that the workpiece is firmly clamped in the
machine vice resp. that the machine vice is firmly clamped on the machine table.
Use cooling and lubricating agents to increase the durability of the tool and to improve the
surface quality.
Clamp the cutting tools and workpieces on clean clamping surfaces.
Sufficiently lubricate the machine.
Correctly adjust the bearing clearance and the guidings.
It is recommended:
Safety
Version 1.2.9 - 2021-09-28
Translation of original instruction
DH26GT | DH28GS | DH32GS
EN
75
Werbung
Inhaltsverzeichnis
