Inhaltsverzeichnis
Werbung
3.4
Fixing
In order to provide for the necessary stability of the geared drill,
it is necessary to firmly connect the geared drill with its foot to the substructure. We recommend
you to use shear connector cartridges resp. heavy-duty anchors.
Fix the foot of the geared drill to the substructure with the provided through-holes.
Through-
bore
Through-
bore
ATTENTION!
Tighten the fixing screws of the geared drill only as much that it is safely fixed and
cannot break away or tilt over.
If the fixing screws are too tight in particular in connection with an uneven substructure it may
result in a broken stand.
EN
DH26GT | DH28GS | DH32GS
92
Img.3-1: Marking of the fixing points of the DH 26 GT, DH 28 GS
Img.3-2: Marking of the fixing points of the DH 32 GS
Img.3-3: Example for the floor fixture DH 28 GS and DH 32 GS
Translation of original instruction
Version 1.2.9 - 2021-09-28
Werbung
Inhaltsverzeichnis
