Disassembly With The Integrated Drill Drift On The B28H - B28Hv - Optimum Optidrill B 24H Betriebsanleitung

4.9.3

Disassembly with the integrated drill drift on the B28H - B28HV

ATTENTION!
The tool and/or the drill chuck will fall
down. Hold the tool
while drifting it out.
ATTENTION!
Do not try to expel the tool when it is in the
intermediate position. This might cause
damages of the integrated drill drift or of
the feed handle.
With the below described procedure the taper
mandrel is being loosened from the drilling
spindle.

Move the sleeve as far down until the loc-
king pin can be moved (Img. 4-18 (b)
1
intermediate position).

Move the locking pin
locking pin engages completely (Img. 4-18
(c) expulsion position).

Press the sleeve lever
powerful movement upwards.
The taper mandrel is pressed out of the

drill spindle.
a) home position
Abb.4-18: Functional diagram of the drill drift (sectional view)
GB
B24H | B24HV | B28H | B28HV
118
3
or the drill chuck
so far, until the
1
with a fast and
2
Img.4-17: Disassembly on B28H - B28HV
Translation of the original instructions
2
3
1
b) intermediate position
c) expulsion position
Operation
Version 2.2.6 - 2020-07-21