Inhaltsverzeichnis
Werbung
Insert the drill in a way that it is exactly positioned between the three clamping jaws of the
quick action chuck.
When drilling make sure that
the suitable speed is set depending on the diameter of the drill,
the pressure must only be such that the drill can cut without load
in case of too strong pressure the drill will get worn early or even might break resp. get
jammed in the hole. If the drill gets jammed immediately stop the main motor by pressing
the emergency stop button,
for hard materials, e.g. steel, use commercial cooling / lubricating agents,
generally always drive the turning spindle out of the workpiece.
1.5
Possible dangers caused by the geared drill
The geared drill is state-of-the-art.
Nevertheless, there is a residual risk as the geared drill operates with
at high speeds,
rotating parts,
electrical voltage and currents.
We have used construction resources and safety techniques to minimize the health risk to per-
sonnel resulting from these hazards.
If the geared drill is used and maintained by personnel who are not duly qualified, there may be
a risk resulting from incorrect or unsuitable maintenance of the geared drill.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must
be duly qualified,
strictly follow these operating instructions.
In the event of improper use
there may be a risk to personnel,
there may be a risk to the machine and other material values,
the correct function of the geared drill may be affected.
Always disconnect the geared drill if cleaning or maintenance work is being carried out, or is no
longer in use.
WARNING!
The geared drill may only be used with the safety devices activated.
Disconnect the geared drill immediately whenever you detect a failure in the safety
devices or when they are not mounted!
All additional devices installed by the operator have to be equipped with the prescribed
safety devices. This is your responsibility being the operating company!
Safety devices on page 79
1.6
Qualification of personnel
1.6.1
Target group
This manual is addressed to
the operating companies,
the operators,
the maintenance personnel.
Therefore, the warning notes refer to both operation and maintenance of the geared drill.
EN
DH26GT | DH28GS | DH32GS
76
Translation of original instruction
Safety
Version 1.2.9 - 2021-09-28
Werbung
Inhaltsverzeichnis
