FISCHER MMS Inspection DFT Betriebsanleitung Seite 191

This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
device does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment!
Information about Specific Absorption Rate (SAR)
This device is designed and manufactured not to exceed the emission limits for
exposure to radio frequency (RF) energy set by the Federal Communications
Commission of the United States.
During SAR testing, this device was set to transmit at its highest certified power
level in all tested frequency bands, and placed in positions that simulate RF
exposure in usage near the body. Although the SAR is determined at the highest
certified power level, the actual SAR level of the device while operating can be
well below the maximum value. This is because the Device is designed to
operate at multiple power levels so as to use only the power required to reach
the network.
The exposure standard for wireless devices employing a unit of measurement
is known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC
is 1.6 W/kg.
The FCC has granted an Equipment Authorization for this model Device with all
reported SAR levels evaluated as in compliance with the FCC RF exposure
guidelines. SAR information on this model Device is on file with the FCC and can
be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after
searching on FCC ID: 2ATFE-MMSINSPEC00.
For this device, the highest reported SAR value for near the body is 0.001134 W/kg.
While there may be differences between the SAR levels of various devices and at
various positions, they all meet the government requirements.
®
MMS Inspection DFT High
185