Drilling; Removing The Drill Chuck From The Spindle Holding Fixture - Optimum Optidrill DX 13V Betriebsanleitung

4.5

Drilling


Switch on the master switch.

Insert and tighten the drill bit.

Clamp the workpiece.

Unlock the emergency-stop.

Close drill chuck protection.

Push Start.
If necessary, change the preset speed with the rotary knob.

Press Stop.
INFORMATION

For a long-term standstill of the machine switch it off at the main switch.
4.6

Removing the drill chuck from the spindle holding fixture

DX13V with B16 spindle
A friction-locking connector holds and centres the drill chuck in the B16 holding fixture.

Rotate the nut downwards; the drill chuck is pushed out of the chuck cone. If necessary,
exert counter pressure on the drill chuck.
INFORMATION

If the nut is no longer available, you can use, for example, an aluminium wedge or other
appropriate lever to remove the drill chuck from the spindle holding fixture.
Img.4-2: Nut for loosening the connection DX13V
The drill chuck and the taper mandrel are loosened from the drill spindle by means of a drill
drift.
WARNING!
Only disassemble the drill chuck if the drilling machine is disconnected from the
electrical supply.
EN DX13V | DX15V
54
Nut
Originalbetriebsanleitung
Operation
Version 1.0.4 - 2021-08-30