Final Assembly Of The Quadrocopter; A) Assembly Of The Radial Arms; B) Assembly Of The Landing Legs - Reely 450 ARF QC09 Bedienungsanleitung



8. Final Assembly of the QuadroCopter

a) Assembly of the radial arms

The model is delivered in flat-pack form. Firstly, click
the four radial arms (1) into flying position. Then
push the clips on the central frame (2) slightly apart
from one another and click the radial arms upwards
(definite clicking into place noticeable).
Should you wish to dismantle the radial arms again
for transportation, you should push the clips on the
central frame slightly apart from one another to
avoid tearing.
Should you not wish to dismantle the
radial arms again for transportation, you
can also permanently affix these using
superglue or cable clips.

b) Assembly of the landing legs

Extend the landing legs (1) into flying position. The
retaining clips (2) must catch clearly noticeably in
the slots (3).
For folding in, slightly push the retaining clips (2)
into the slots (3) with a small screw driver in order
to avoid breaking the plastic parts.
A red direction indicator is mounted to one of the
landing legs. This direction indicator should always
be considered as „forwards" when flying.
In harder landings, the landing legs will fold in. This is normally expected by us. Should you wish to avoid
this effect or if you no longer wish to fold away the landing legs for transportation, you can also permanently
affix the landing legs using superglue.
54
Figure 2
Figure 3