Acoustic Signal Encoder Messages - Reely 450 ARF QC09 Bedienungsanleitung


13.

Acoustic Signal Encoder Messages

If the flight control determines any malfunctions during self-test, motor start or in flight, these functional problems are
acoustically indicated via the signal encoder. The following codes are possible:
Error
Gyro error at zero reconciliation roll
Gyro error at zero reconciliation pitch
Gyro error at zero reconciliation yaw
Motor error front
Motor error rear
Motor error right
Motor error left
Emergency landing
Undervoltage level 1
Undervoltage level 2
Signalling readiness for flight
Signalling zero reconciliation
Signalling motor start
Signalling motor stop
The interferences shown are usually not permanent but have been caused by temporary causes.
Disconnection of the battery generates a „Reset" that usually eliminates the error. The cause for perma-
nent interferences must be found. Also observe all notes described in these operating instructions, item
„LED displays" in acoustic messages of the signal encoder.
74
Sound signal
1 x brief, then 1 s break
2 x brief, then 1 s break
3 x brief, then 1 s break
1 x long , 1x brief beep, then 1 s break
1 x long , 2x brief, then 1 s break
1 x long , 3x brief, then 1 s break
1 x long , 4x brief, then 1 s break
Permanent sound
1 Hz (slow sound sequence)
2.5 Hz (quick sound sequence)
1 x brief (0.5 s)
1 x brief (0.5 s)
1 x brief (0.5 s)
1 x brief (0.5 s)