E) Binding The Transmitter With Quadrocopter; F) Calibration And Unlock - Reely DIY Bricked Drone Bedienungsanleitung

• Attach your smartphone to the smartphone holder and view the live image from the quadrocopter's camera while
you use the controls of the app. Loosen the screws at the holder to match the size of your smartphone. Then tighten
the screws so that the smartphone sits securely in the bracket.
• Check whether your smartphone is suitable for the holder. Observe the side buttons of your smartphone in order
not to put too much force on them while it is placed in the smartphone holder. One side of the holder is therefore
equipped with a padded foam.

e) Binding the Transmitter with Quadrocopter

The transmitter uses a 2.4 GHz transmission frequency and achieves a transmission range of up to approx. 30 - 50
metres, depending on the environment and ambient conditions.
• Check that your flight battery has been correctly charged.
• Place your quadrocopter on a flat surface.
• Connect the battery to the aircraft, the front LED lights will keep flashing.
• Turn on the transmitter and push the left throttle joystick (7) up and down to bind the aircraft. When you hear a
beep sound, it means the transmitter has matched the aircraft and the LED lights will stop flashing. The binding is
complete.

f) Calibration and unlock

• Before the first flight the aircraft needs to be calibrated.
Furthermore, if after a flight the aircraft is in deviation of
direction due to a hit or crash from outside, please land it to
the flat ground. For calibration make sure that the front side
of aircraft (LED at the front) is in the same direction as the
transmitter front side. Then calibrate the aircraft.
• Push left throttle joystick on the transmitter to the bottom right
and push right direction joystick to the bottom left (Please
make sure pushing 2 joysticks at the same time). See Fig. 4.
• The two front LED lights change from quick flash to solid
bright. When the transmitter makes one beep sound the
calibration is completed and all trimmers are reset.
• After finishing the calibration turn the throttle sticks outwards
to unlock. See Fig. 5.
• The propellers of the quadrocopter turn at low speed and the
aircraft is ready for take-off.
38
Fig. 4
Fig. 5