C) Programming Of „Throttle; D) Programming Of „Yaw; E) Programming Of „Pitch - Reely 450 ARF QC09 Bedienungsanleitung

c) Programming of „Throttle"
Connect the charged battery to the QuadroCopter. The model starts with a self-test and directly continues with
programming of the channels. On the basis of the throttle setting, the QuadroCopter automatically recognises which
channel you would like to use for the throttle.
The red „LED2" briefly flashes during initialisation as confirmation.
d) Programming of „Yaw"
Now move the yaw lever (see figure 13) to the left
to full deflection and hold it there for at least one
second.
The QuadroCopter thus recognises the YAW
channel and memorises this.
Move the YAW lever back to neutral position with
the THROTTLE still on zero.
As confirmation, the QuadroCopter's red LED
flashes in a cycle of 2 (2x short flashes, then a pau-
se, etc.).
During the respective configuration
step, the green LED shows the channel
as long as the lever is still being
pushed! However, only the red LED is
important for the progress indicator!
During the programming process, please ensure that you only move the required lever, otherwise the setting will not
be recognised!
e) Programming of „Pitch"
Move the PITCH lever (see figure 14) to full
deflection for GIVE PITCH upwards and hold it
there for at least one second.
The QuadroCopter thus recognises the PITCH
channel and memorises this. Move the PITCH lever
back to neutral position, continue to leave the
THROTTLE on zero.
As confirmation, the QuadroCopter's red LED2
flashes in a cycle of 3 (3x short flashes, then a pau-
se, etc.).
64
Figure 13
Figure 14