F) Programming Of „Roll; G) Programme Switch For „Agility Mode - Reely 450 ARF QC09 Bedienungsanleitung

f) Programming of „Roll"
Move the ROLL lever (see figure 15) to full
deflection for ROLL LEFT and hold it there for at
least one second.
The QuadroCopter thus recognises the ROLL
channel and memorises this. Move the ROLL lever
back to neutral position with the THROTTLE still
on zero.
As confirmation, the QuadroCopter's red LED
flashes in a cycle of 4 (4x short flashes, then a pau-
se, etc.).
g) Programme Switch for „Agility Mode"
The installed Flight Control „QC 09" has high-quality MEMS sensors installed for flight position stabilisation.
This leads to relatively easy to control flight characteristics similar to those of a coax helicopter.
The QuadroCopter agility is limited by these sensors, however. Activating the „agility mode" function limits
the Flight Control sensors in their functions. The QuadroCopter can be controlled much more agile around
all axes in this mode. The flight characteristics are now closer to those of a helicopter. Simple freestyle
flight (looping, rolls) is possible as well.
The flight characteristics with active „Agility mode" function are not suitable for beginners. If you do not
have sufficient flight experience with QuadroCopters and/or helicopters, we recommend performing the
first flights with active „agility mode" with appropriate care. The „agility mode" function is not possible in
beginner or sport mode, but in user mode only.
To programme channel 5 to activate „agility mode",
a switch at the remote control transmitter (figure
16) must be operated twice (on - off).
When teaching in channel 5, the last position of
the taught-in switch means that the „agility mode"
function is deactivated in this switch position.
As confirmation, the QuadroCopter's red LED goes
off and the green LED is lit permanently.
This is the end of the teaching process.
Figure 15
Figure 16
65