Connecting The Drive Battery - Reely Wavebreaker 2.0 Bedienungsanleitung

d) Connecting the drive battery
Before connecting the drive battery to the model's on-
board electronics, check the position of the on/off switch
(1) on the model. The switch must be in the rear "OFF"
position.
Then insert the drive battery plug (2) into the model's elec-
tronics module (3). To do this, use the matching connector
with retaining clip (4) on the electronics module (the same
can be found on the plug-in charger).
Important:
Push the connector between the two motors so
that it cannot come into contact with the rotating
drive parts.
40
Figure 7