Reely Wavebreaker 2.0 Bedienungsanleitung Seite 48

15. Troubleshooting
This model and the remote control were built using the latest technology. However, faults and malfunction may still
occur. The following section shows you how to troubleshoot potential problems.
Problem
The transmitter does not respond and
the LEDs remain off.
The green LED on the transmitter
flashes.
The model does not respond to the
remote control.
Motors do not run.
The LED on the electronics module
flashes continuously.
Travel time is too short.
The model travels in one direction
when moving straight ahead.
The model vibrates with running
motors.
48
Solution
• Check the batteries in the transmitter.
• Check the polarity of the batteries in the transmitter.
• Check the function switch.
• Replace the batteries in the transmitter.
• Repeat the power on procedure.
• Check the drive battery and connectors.
• There is interference from other 2.4 GHz remote controls.
• Check the drive battery charge status.
• Check if the drive shafts run smoothly.
• Repeat the power on procedure.
• Check the function of the remote control.
• Replace the batteries in the transmitter.
• Repeat the power on procedure
• Fully charge the drive battery.
• Check the charger for functionality.
• Replace the drive battery.
• Adjust steering trim on the transmitter.
• Check the ease of movement of the drive motors.
• Check if the drive shafts run smoothly.
• Check the condition of the propellers.
• Check the condition of the propellers.
• Check the condition of the drive shafts.
• Check the fan blades of the motor cooling.