Receiving The Product; Transporting The Solution - Grundfos iGRID Montage- Und Betriebsanleitung

2.4.2 Type key
Ex. iGRID P- P 9 TCX NA- PS14- 110 AA- X- BFRMS
Pos. 1 2 3 4 5
Pos. Description
1 Product family
Product type
2 P: Pressure Zone
T: Temperature Zone
System type:
P: Pit
3
C: Cabinet
S: Skid
4 Number of main pumps (1-9):
Pump type:
T: TPE
5
C: CRE
X: Other
Pressure Equipment Directive (PED) category:
P1: PED category I
6
P2: PED category II
NA: PED is not applicable
7 Maximum operating pressure (PS)
8 Maximum liquid temperature (°C)
Pipe connections (inlet/outlet)
A: DN 65
B: DN 80
9 C: DN 100
D: DN 125
E: DN 150
F: DN 200
Design variant:
A: Standard
10
X: CSU variant
Q: CSU variant with customer delivered component
Options:
B: With booster pumps (only relevant for Temperature
Zone)
F: Flowmeter
R: Pressure reduction valve
M: Motor valve
11
S: Strainer
E: Electrical panel
O: Other
or
XX: More than 5 options
6 7 8 9 10 11

3. Receiving the product

3.1 Transporting the solution

Make sure that the solution is correctly fastened. The
exterior pipe connections are not intended for fastening
during transport. See figure Fastening during transport.
When transporting and handling the solution at low
temperatures, take into account that the impact resistance
of the solution may be reduced.
Transport the solution in a vertical position, and fasten it to
the transporting vehicle.
Provide adequate lifting equipment at the location of delivery.
The weight is shown on the nameplate and the product label.
Follow the instructions below when transporting and handling
the solution:
• Secure the solution properly during transport.
• Do not tilt the solution when removing it from the vehicle. Lift
the solution with lifting equipment attached to the lifting brackets
of the solution.
• Handle and lift the solution according to local regulations. See
section about handling and lifting the solution.
• Use only approved straps made of textile or similar material
when lifting the solution to or from a vehicle or moving it at the
construction site.
• Do not expose the solution to point loads.
• Do not drag the solution across the floor.
• Do not expose the solution to sharp edges.
• Place the solution on a level surface.
Fastening during transport
The solution is fitted with lifting brackets. Always use the
lifting brackets when handling the solution.
Related information
3.3 Handling and lifting the solution
7