Herunterladen Diese Seite drucken

Ducati Performance 96680611A Montageanleitung Seite 129

Spezifische diebstahlsicherung

Werbung

Atenção
Caso o quadro do veículo seja acendido (key-on) ou seja
pressionada a tecla (3B) do telecomando (alarme de pânico), o som
da sirene é restabelecido.
Alarme de pânico
Passados os 5 segundos da ativação (led no painel de
instrumentos aceso intermitente) pressione a tecla (3B) do
telecomando, a unidade eletrónica executa um ciclo de alarme
durante 4 segundos.
Para interromper o ciclo de alarme, pressione novamente a tecla
(3B).
Sensor de inclinação
O sensor memoriza a posição da moto no ato da ativação do
alarme.
Um desvio maior que dois graus em um dos três eixos (x, y, z) é
considerado causa de alarme.
Não é possível calibrar este sensor.
Memória de alarme
Se a unidade eletrónica registar uma ou mais causas de alarme,
estas são sinalizadas aquando da desativação através de um
lampejo dos indicadores de posição e por um número de "beeps"
igual aos alarmes ocorridos (máx. 7 sinalizações).
Auto-alimentação
O sistema anti-roubo é dotado de baterias compensadoras que
garantem o seu funcionamento mesmo que seja cortado o cabo
que liga a bateria ao sistema elétrico do veículo.
Telecomandos
Os telecomandos, para o próprio funcionamento, utilizam
baterias alcalinas que são facilmente encontradas no mercado.
Se um telecomando não for utilizado por muito tempo, a bateria
interna deverá ser removida para prevenir danos causados pelo
vazamento de ácido da mesma. Para além disso, os telecomandos
não deverão ser submetidos a colisões violentas e não deverão
sofrer imersões em nenhum tipo de líquido. Uma progressiva
diminuição da capacidade de transmissão, indica que a bateria
do telecomando está se descarregando. Substituir a bateria
logo, evitará encontrar-se com o alarme ativado e o telecomando
inutilizável.
Substituição das baterias do telecomando
Para substituir a bateria do telecomando, abra-o como o indicado
na figura, fazendo alavanca com uma chave de parafusos na
fissura.
Substitua a bateria descarregada com uma nova do tipo CR2032,
respeitando a sua polaridade.
Atenção
Antes de jogar fora os telecomandos que não são mais utilizáveis,
remova a sua bateria e elimine-a conforme as normativas em vigor.
Não disperse a bateria no ambiente.
ISTR 854 / 00
Warning
When vehicle instrument panel is switched on (key-on) or if
button (3B) on remote control is pressed (panic alarm), the siren is
enabled.
Panic alarm
After 5 seconds from enabling the system (dashboard LED
blinking) press button (3B) on the remote control to have the
control unit perform a 4-second alarm cycle.
To interrupt the alarm cycle, press button (3B) again.
Tilt sensor
The sensor memorises the motorcycle position when the alarm
was triggered.
A movement greater than two degrees on one of the three axes
(x, y, z) is considered the cause of an alarm.
This sensor cannot be calibrated.
Alarm memory
If the control unit identifies one or more alarm causes, they are
signalled when alarm is unarmed by means of a further flashing
of the parking lights and a number of beep sounds equal to the
number of triggered alarms (max. 7).
Backup battery power
The antitheft system is equipped with internal batteries that
guarantee its operation even when the power supply cable
connected to the vehicle's battery is intertrupted.
Remote controls
The remote controls are powered by standard alkaline batteries,
available on the market. Remove the battery if a remote control is
expected not to be used for some time, in order to avoid damaging
due to possible acid leaking off the batteries.
Remote controls shall not be subjected to shocks nor submerged
into any fluid. A progressive decrease in signal range indicates that
the remote control battery is getting flat.
Change the battery in good time or you could incur in the case
where alarm is armed and your remote control battery is flat.
Changing the remote control battery
To change the remote control battery, open remote control as
shown, prising in the slot using a screwdriver.
Change the flat battery with a new one type CR2032, and fit
correctly.
Warning
Before disposing of the remote controls, remove the battery and
dispose of it according to the prevailing rules. Do not release
batteries in the environment.
41

Werbung

loading

Diese Anleitung auch für:

Performance 96680612a