Back Pedal Brakes; L Ighting System; Lights - Flyer FIT E-Bike System Originalbetriebsanleitung

Quelle: Shimano techdocs
®
New rim (with points
to indicate wear)
New brake pads
Brake discs and brake pads are particu-
larly subject to wear . Have these safe-
ty-related components regularly checked
for wear and changed as required by
your FLYER specialist retailer .
If the brake system needs to be cleaned, contact
your FLYER specialist retailer .
The component manufacturer's instructions on
how to clean the brake system are provided in the
respective brake system manual .
Only allow your FLYER specialist retailer to
maintain the brake system and change individual
brake system components . Only original spare
parts may be used . Otherwise it is possible that
the functionality of your FLYER e-bike may be im-
pacted or damaged .
Have the brake pads regularly checked accord-
ing to manufacturer specifications by your FLYER
specialist retailer .

17.4 Back pedal brakes

If your FLYER is equipped with back pedal
brakes, brake by pushing the pedals backwards
instead of forwards . This means that your bicycle
Worn rims
Worn out brake pads
71
will not freewheel and you are unable to rotate the
pedals backwards freely as you otherwise can .
Back pedal brakes work best when both
cranks are in a horizontal position . If one
crank is pointing up and the other one
down, less force can be applied and
braking is less effective.
The effectiveness of back pedal brakes
can deteriorate substantially on long
slopes if they are used on their own .
This type of braking system can become
very hot from continuous braking . Use
the rim brakes too on long slopes .
Wait until the back pedal brake has
cooled down and do not touch the brake
drum .
Ensure that the brake anchor plate is
correctly attached with the appropriate
screw when removing or installing it .
18. L ighting system
Your FLYER e-bike's lighting system is usually
powered by the battery . When the battery is emp-
ty, the light should still work for about one hour .
The headlight must be aligned to illuminate the
road according to the legal regulations of your
country .
Have the lighting system checked and, if
necessary, replaced by your FLYER spe-
cialist retailer if a fault occurs .

18.1 Lights

Different lighting systems are installed depending
on the area of use and bicycle type .
FLYER with pedal assist over 25 km/h with
high beam
Basic setting: when the system is activated, the
low beam/daytime running light is automatically
switched on . Light button function: Switch be-
tween low beam/daytime running light and high
beam .
Switching between low beam/daytime running
light: Automatic switching based on the integrated
light sensor .
FLYER E-mountainbikes
If you have chosen to add the optional lights to
your FLYER e-mountainbike, the settings are as
follows:
Basic setting: when the system is activated, the
light remains switched off. Light button functions:
EN