Configuring The Assistance Modes; Lights; Electrical Motor - Flyer FIT E-Bike System Originalbetriebsanleitung

5.24 Configuring the assistance
modes
You can configure the assistance level via the +
and – buttons on the FLYER RCO remote control
operating console .
HIGH
Maximum assistance for active
riding up to high pedalling
frequencies .
STD Powerful assistance level for
active riding in city traffic
ECO Effective assistance level with
optimum efficiency for maximum
range .
AUTO The system automatically and
independently selects the correct
assistance for the current riding
situation .
OFF No motor assistance . You
ride your FLYER like a normal
bicycle . All on-board computer
functions are available .
Pushing aid

5.25 Lights

Different lighting systems are installed depend-
ing on the area of use and bicycle type . If this is
done using a daytime running light function, the
system will always switch automatically between
low beam and daytime running light .
FLYER with pedal assist over 25 km/h with
high beam
Basic setting: when the system is activated, the
low beam/daytime running light is automatically
switched on .
Light button function: Switch between low beam/
daytime running light and high beam
FLYER e-mountainbikes
Basic setting: when the system is activated, the
light remains switched off. Light button functions:
Activate the light by pressing the light button;
switch between low and high beam (if high beam
function is available) by pressing the light button
again. Switch off the light by pressing and holding
the light button (at least 1 second) . Switching bet-
ween low beam/daytime running light: Automatic
switching based on the integrated light sensor .
FLYER with pedal assist up to 25 km/h
Basic setting: when the system is activated, the
light automatically switches on .
Light button functions: Switch off the light by
pressing the light button . Switch the light back on
by pressing the light button again .

5.26 Electrical motor

How the electrical motor works
The motor starts working as soon as you start
pedalling when one of the assistance levels has
been selected .
The performance of the motor depends on sev-
eral factors:
• The force used while pedalling .
The assistance is more gentle when you
pedal with low force than when you pedal with
higher force, e .g . while riding uphill . However,
this increases the power consumption and
decreases the range .
• The assistance mode
The higher the level of assistance, the more
power the motor will provide . However,
high motor performance means high power
consumption . The lowest assistance mode
provides the least assistance but also the
longest range .
Range
Any specified range information is usually ob-
tained under optimal conditions . Ranges achieved
under everyday conditions will usually be shorter .
Please consider this when planning your route .
The range depends on many factors . These in-
clude battery capacity, motor assistance level
selected, geographical conditions, road surface,
driving style, environmental temperature, the
weight of the rider, tyre pressure and the technical
state of your FLYER e-bike .
Extreme ambient temperatures may reduce the
range . The operating temperature should be kept
within the range from -5 degrees to 40 degrees .
Driving without drive assistance
You can also ride your FLYER without drive as-
sistance by selecting the assistance level "OFF" .
However, you must ensure that your system is
always switched on .
Never drive without a battery or with your
system switched off, as the functions of
the operating unit and the lighting func-
tions are not available in this case .
Always remove the battery before clean-
ing, maintaining or repairing your e-bike .
Ensure that you do not touch and thus
possibly connect contacts when clean-
ing or maintaining the battery .
You risk being hurt and the battery may
suffer damage if the contacts are live.
Do not use a strong water jet or high-pres-
sure cleaner for cleaning . The cleaning
liquid may enter sealed bearings due to
33
EN