Safety Precautions - Flyer FIT E-Bike System Originalbetriebsanleitung

Never ride with a seat post extended fur-
ther than the maximum marker as this
could result in serious falls and injury .
Children and persons who are not confi-
dent cyclists should be able to touch the
ground with the tips of both feet . Other-
wise, when stopping they run the risk of
falling and suffering serious injury.
Seat position
ST OP
The horizontal position of the seat can and should
be set too .
You are in the optimal riding position when your
front knee is directly above the pedal while the
crank is horizontally aligned .
The horizontal adjustment of the seat may only
be performed within the markers and within the
range specified by the manufacturer.
Test whether the seat post and the seat
are firmly attached before you ride off.
To do this, hold the seat at the front and
back and attempt to turn it . It should not
move .
Telescoping seat post
FLYER Uproc models can
be supplied ex works with a
height-adjustable seat post .
This allows the seat height
to be lowered or adjusted
rapidly and safely in difficult
terrain, for example before
big drops .
The height of the seat can lowered by operating
the switch on the handlebars while pushing down
on the seat . If you want to return to your normal
riding position, simply operate the handlebar
switch and briefly remove any load pushing down
on the seat . The support then resets the seat to
its usual height .
It is essential that you read the part ma-
nufacturer's operating manual when set-
ting up and operating suspension seat
posts and telescopic seat posts .
FLYER MT171 seat post
If your FLYER E-MTB is fitted with a MT171
adjustable seat post, please note the following
points . The FLYER MT171 allows you to cycle ef-
ficiently and tackle technically demanding routes.

SAFETY PRECAUTIONS

Please read the user manual carefully before as-
sembling and using the FLYER MT171 seat post .
Failure to follow the instructions may lead to sever
injuries or death .
1 . Adjusting the height of the seat post during the
ride may cause you to lose control of the seat
post .
2. Never ride on a modified or excessively worn
FLYER MT171 seat post . Do not modify the
FLYER MT171; any modifications will result in the
warranty being cancelled and may cause invisible
damage to and/or faults in the seat post .
3 . Loose, overly tightened, damaged or worn
parts may cause unexpected faults. Check the
seat post regularly for wear or damage . If there
are signs of wear, cracks or dents in the seat post
or parts of it, stop using the seat post straight
away and contact an authorised FLYER dealer to
inspect, repair or replace the parts .
4. Before setting off, please make sure that all of
the screws in the FLYER MT171 seat post are
properly fastened to the recommended tightening
torque .
5 . Fastening the seat post clamps too tightly af-
fects whether you can adjust the seat post hight;
you can find the recommended tightening torque
on the seat post clamp or in the technical data .
58