Storing The Battery; Pushing Aid - Flyer FIT E-Bike System Originalbetriebsanleitung

5.30 Storing the battery
When not in use for a long period of time, store the
battery at a charge level of approximately 30% to
60% . Check the charge level after 6 months . If
necessary, recharge the battery to about 30% to
60% capacity .
If possible, store the battery in a dry, well ven-
tilated place in temperatures between 10 °C und
40 °C. For a long lifespan, it is beneficial for a
battery to be stored at room temperature, around
20°C. For example, do not leave the battery in the
car in the summer and store it away from direct
sunlight .
The battery must be stored on a non-flammable
surface (stone, concrete) .
Do not store the battery near combustible or
highly flammable objects.

5.31 Pushing aid

Push-
ing aid
The pushing makes it easier for you to set off on
the e-bike . Do not use the pushing aid to ride the
e-bike .
All FLYER e-bikes are equipped with a pushing
aid . This is limited to 6 km/h in the fastest gear .
The FLYER can conveniently be moved out of
underground parking or along steep paths by ac-
tivating the pushing aid .
Switch to pushing aid mode by firstly pressing and
holding the pushing aid button for more than 1 .5
seconds . Then release the button and press the
pushing aid button again to activate pushing aid
mode .
The pushing aid is activated if
– You press the – button in the pushing aid mode
– A speed of 6 km/h is exceeded.
When using the pushing aid, the wheels
must be in contact with the floor to avoid
the risk of injury .
42