Error Codes; Identifying Errors; Operation With Flyer D0 Display And; Flyer Rc0 Remote Control - Flyer FIT E-Bike System Originalbetriebsanleitung

5.6 Error codes

The parts of the e-bike system are monitored at
all times during use and charging . If an error is de-
tected, an error code will be displayed on the con-
sole . To switch the console back to the standard
display, press the joystick button to acknowledge
the error . If the error cannot be acknowledged,
troubleshoot it according to the table below or
contact your FLYER specialist retailer . Depending
on the error code, the assistance is automatically
stopped as necessary . You can continue to use
the bicycle normally without the drive even if the
assistance function is no longer being provided
by the motor . If an error is displayed, troubleshoot
it according to the measures described in the ta-
ble below and/or contact your FLYER specialist
retailer .
5.6.1 Identifying errors
An error can be clearly identified on the basis of
the category and code displayed. Text indicating
the error category is also always displayed .
2 3
1 Error text, 2 Category, 3 Code
5.7 Operation with FLYER D0 dis-
play and FLYER RC0 remote control
Your FLYER with Panasonic drive is operated via
the FLYER RC0 remote control .
FLYER RC0 remote control operating console
FLYER Display D0
1
1. On/Off button
To activate the system, press the on/off button on
1
the display for at least one second . The "Drive"
menu will then be shown on the display .
The system can only be activated if a
sufficiently charged battery is used.
To activate the system, press the on/off button on
the display for at least one second . The "Drive"
menu will then be shown on the display .
The system can only be activated if a sufficiently
charged battery is used .
To turn off the electrical system, press the on/off
button for at least one second .
The FLYER D0 display is operated using the
FLYER RC0 remote control operating console,
so that your hands can remain on the handlebars
while you ride .
Press the "Mode" button to switch between the
individual main menus on the display .
The following four main menus are available:
Drive: Main view with key information such as
speed, remaining range etc . The sys-
tem always starts up in this view .
Trip: Information about the current journey
Speed: Information on the rider's average and
maximum speed
Data: Information on the pedal frequency and
total kilometres
26