B) Switching The Menu; Servo Reverse - Reely Hughes Bedienungsanleitung

b) Switching the menu

The AP flight model programme offers 5 different menu items for programming. To choose this function, first switch on
the transmitter.
Press the "UP" and "DN" buttons at once to access the "servo reverse" menu
Press the "UP" and "DN" buttons at once twice to access the "full deflection" menu
Press the "UP" and "DN" buttons at once three times to access the "servo centre settings" menu
Press the "UP" and "DN" buttons at once four times to access the "dual rate" menu
Press the "UP" and "DN" buttons at once five times to access the "throttle hold" menu
Press the "UP" and "DN" buttons at once six times to access the "normal" menu
If you want to return to normal mode after a programming step, press the "INC" and "DEC" buttons at once.
If no programming steps are made for more than 30 seconds, the programming is automatically interrupted
for safety reasons. The transmitter is then in normal operation again. The changes made before the
programming interruption are saved as new memory content.
c) Servo reverse
With this function, you can reverse the operating direction of the servos. To
choose this function, first switch on the transmitter. Press the "UP" and "DN"
buttons at once Use the "UP" and "DN" buttons to select servo functions
"r1" to "r6".
Use the "INC" and "DEC" buttons to switch between normal "NOR" and
reverse "REV".
Attention!
If you change this function, you have to carefully check all control commands of the remote control afterwards
to make sure that you haven't accidentally changed the function direction of the wrong servo. The wrong
reaction of a servo to a control command is among the most frequent causes of crashing.
134
Figure 10
Figure 11