B) Switching On The Transmitter And The Model Airplane - Reely 1551510 Handbuch

b) Switching on the transmitter and the model airplane

First push the control stick with the motor function (also
see figure 6, item 6) to the bottom position right at your
body. The flight battery in the model must be connected,
but the on/off switch (also see figure 5, item 2) must be in
the position "OFF".
Then briefly push the on/off button with your finger (also
see figure 6, item 4).
The transmitter emits a signal sound and the LED of the
operating control display (see figure 6, item 7) starts to
flash. The transmitter now tries to connect to the receiver.
Now push the on/off switch at the model airplane (2) to the
position "ON". The transmitter emits a brief signal sound.
Both the LED in the transmitter (7) and the LED in the
model airplane (8) now light up permanently.
Caution, important!
Before you test the motor function, ensure that
the model is reliably secured against rolling
away or held securely. There must be no ob-
jects in the turning or intake area of the propel-
lers.
In order to activate the motor control, the control lever
for the motor function (also see figure 6, item 6) must be
pushed all the way forward.
The transmitter emits a brief signal sound. Pull the control lever for the motor function back to the bottom position
again at once then. The transmitter then emits a slightly longer signal sound.
In order to start the motors, push the control lever all the way forward briefly again (full throttle position) and then back
to the bottom-most position right away. The motors briefly start up under high load and can then be carefully adjusted
with the control lever for the motor function.
In order to take the model out of operation again, first push the on/off switch at the model airplane to the "OFF" position
and then push the on/off button at the remote control for approx. 2 seconds.
Attention!
In order to protect the batteries, the transmitter has an automatic deactivation function that switches off the
transmitter at rest after approx. 2 minutes.
If the LED of the operating control display starts to flash during operation, the inserted batteries must be replaced by
fresh ones.
Figure 8
37